![]() ![]() Loctite naval jelly rust dissolver will remove the rust right before your eyes. Fast drying latex rust converter coating that is applied to rusted metal to stop rust, protect the surface and acts as a primer for the finish coat. It is the ideal product for heavily rusted items. Converts rust to a neutral surface ready to paint over. If you are concerned about contaminating the water table when rinsing off the Naval Jelly, you can neutralize the run off with pot ash.Not recommended for use on stainless steel, aluminum, chrome, painted surfaces, plastics, marble, cement, or fiberglass. Easy to use spray applicator help to make the application quick. Naval Jelly is not recommended for use on the following materials: It removes rust from metal surfaces such. If there is any rust remaining, repeat the above steps as many times as needed to remove all the rust.ĭo not use Naval Jelly on the following materials Loctite Naval Jelly Rust dissolver is the original rust treatment formula that has been used for over 40 years. Rinse off with a garden hose and inspect. ![]() Then brush on a liberal coating of Naval Jelly and let stand for fifteen minutes but not longer than fifteen minutes. Bros Automotive 191 subscribers Subscribe 1. Naval jelly can be used safely as long as you know what safety pecautions you need to take when using it.īegin by removing all loose dirt and rust with a wire brush. 0:00 / 3:08 Easy Way to Remove Rust From Car With Loctite Naval Jelly Rust Remover K. I did not put all this first to scare you away from using this product, but, as I said in my article, “The 4 Cardinal Rules of DIY”, safety first, always safety first. There should be no children allowed in the area where you are working with Naval Jelly.ĭo not dispose of Naval Jelly by flushing it down the drain. /rebates/2fp2fLoctite-Naval-Jelly-16-fl-oz-Rust-Dissolver-6-Pack-5534722f203009402&. It contains phosphoric acid, which is capable of converting rust to a water-soluble. If you swallow any Naval jelly, do not induce vomiting, but drink large amounts of water and head for the ER.īy now it should be obvious that this is a product that you need to keep out of the reach of children and pets. Naval jelly is sold under the brand name Loctite Rust Dissolver. If you do get any in your eyes, wash your eyes out with plenty of water for at least fifteen minutes and then see a doctor immediately. If you do get some on your skin, wash it off immediately using plenty of soap and water.Īlways wear safety glasses, safety goggles, or a full-face shield to prevent the Naval Jelly from getting into your eyes. Inhaling the fumes can seriously damage your respiratory system.Īlways wear rubber or plastic gloves when working with naval Jelly. Use Naval Jelly in well ventilated areas only. Safety precaution to be observed when using Naval Jellyĭo not use in confined spaces. Water makes up the non-hazardous portion by more than 50 percent. ![]() Naval Jelly does contain Phosphoric Acid (10 to 30 percent by composition) and minute amounts of Sulfuric Acid (0.1 to 1.0 percent by composition), as well as other hazardous chemicals-Phosphate ester (1 to 5 percent), Polysaccharide (1 to 5 percent), and Isopropyl alcohol (1 to 5 percent). Today, Naval Jelly is manufactured by the Loctite Corporation and sold as LOCTITE ® NAVAL JELLY RUST DISOLVER. You need to have this wonder working chemical in your shops chemical cabinet right next to those cans of Specialty WD-40 Products. Naval Jelly, a pretty, pink gel, is really available at any hardware store or home center. Naval Jelly, the miracle rust remover, has been around for over twenty-five years, yet most DIY people are unaware of it and continue to remove rust the old fashion way with scrapers, wire brushes, and sandpaper. ![]()
0 Comments
Leave a Reply. |